What's new
Photoshop Gurus Forum

Welcome to Photoshop Gurus forum. Register a free account today to become a member! It's completely free. Once signed in, you'll enjoy an ad-free experience and be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

How to remove glare on cupboard?


mrk123

Member
Messages
6
Likes
6
This is a crop of an image.
I have tried content fill and clone stamp but can't sem to get it right. Fill tool not working. I want to take these 2 hot spots out... I nearly left them in but it ruins the image, looks sloppy.
Am I using contnt fill wrong?
AS it is here I have not shown with fill or clone, just how it is.
I normally shots without lights off but this was the first shot and I wasn;t thinking.

Would a COLOUR LAYER be the best bet, and paint it in / over?

Screen Shot 2023-03-01 at 07.49.30.png
 
Last edited:
Tricky, not perfect but a 5 min fiddle...

mrk123_01.png

Used 'Content Aware Fill' for the bulk of it, clone stamp for the top 'edge' and a little 'patch' to smooth things out.

There may be more usable data for 'content aware' to use in the full image, possibly giving a better result, as this is a crop it is limited.

Regards.
MrToM.
 
Both are good but second one is clean!
How hell ya do that?! On a scareen grab too?!
Can ya share, I have not delivered th photos yet!
 
Annoying job... I ended up using marquee tool and copying th panel on the left and just dragged it across, and used normal blend mode and lowerd the opacity and usd a fathered eraser tool to blend... done the job... Content aware was not workig for me! Oh but did content aware the lights out.

Screen Shot 2023-03-01 at 16.53.31.png
 
Just another possibility.

I used a combination of the Clone Stamp Tool, the Brush Tool, and Content Aware fill.

I did create selections to constrain the areas I worked in with the Pen Tool.
First selection.
Screen Shot 2023-03-01 at 10.46.23 AM.png

Worked the area first with a content fill, added some clone stamping to even it out.
Then I used the Brush Tool on a very low setting to blend.
Screen Shot 2023-03-01 at 10.46.35 AM.png

Repeat for each panel.
Screen Shot 2023-03-01 at 10.51.41 AM.png
Screen Shot 2023-03-01 at 11.01.05 AM.png

Don't forget this glare!
Screen Shot 2023-03-01 at 11.13.13 AM.png

CubboardDoorGlareRemoval_01.png
 
Well afer all that the colour was wrong! I had to change it! Thankfully I always shoot a flash shot which gives a perfecr colour reading provusing the light source is white. The ceiling is still a little bright for me but I am done now! Not perfect but I am not getting paid enough to keep going in!
Screen Shot 2023-03-02 at 17.43.19.png
 

Back
Top