Align objects in canvas

[Allan Prospero]

Hello, this is my very first post. I actually registered because I'm struggling with an issue which is driving me nuts. First off, my understanding of the app is very very limited, I can barely tell the difference from between various components and commands but I desperately need to make some changes on a PDF file. Am I allowed to upload it and then ask you questions? Thanks.

 

[IamSam]

Am I allowed to upload it and then ask you questions?

Sure, as long as it does not contain nudity or profanity.

 

[Allan Prospero]

Sure, as long as it does not contain nudity or profanity.

No, it's a floor plan.
So, I need to erase all the text (not the measurements) and then place the rest of the object in the absolute center of the canvas. Before doing so, can I resize the canvas to something like 3200x2300 and then place the floor plan to the middle and center?

 

[Allan Prospero]

I took out the text, trimmed, sharpened, enlarged so width fit 3200 and height padded to 2300 per your request
Hope that is what you wanted
John Wheeler

View attachment 115458

Care to share how? I have two more files like these and I wanna do it myself. Thank you though for doing this.

 

[thebestcpu]

You bet, my mistake and took out my post and here are the instructions
1) Paint pure white over the text
2) Use the Image > Trim command Using white as the upper left corner
3) I used Topaz Gigapixel to enlarge to provide a sharper image yet all you need to do is use Image > Image Resize and set pixel width to 3200 (don't worry about height for this image) You should now have the width solved
4) Now used Image > Canvas Size and set the dimension type to pixels (don't check relative) and set height to 2300 pixels

That should give you the result. If you need any more clarity just ask
Hope this gets you started
John Wheeler

 

[Allan Prospero]

You bet, my mistake and took out my post and here are the instructions
1) Paint pure white over the text
2) Use the Image > Trim command Using white as the upper left corner
3) I used Topaz Gigapixel to enlarge to provide a sharper image yet all you need to do is use Image > Image Resize and set pixel width to 3200 (don't worry about height for this image) You should now have the width solved
4) Now used Image > Canvas Size and set the dimension type to pixels (don't check relative) and set height to 2300 pixels

That should give you the result. If you need any more clarity just ask
Hope this gets you started
John Wheeler

Thank you, I'll try that out.